SystemAir SAVE Series - SAVE VTR 500 Filter Replacement; Filter Replacement Steps for SAVE VTR 500; SAVE VTR 700 Filter Replacement; Filter Replacement Steps for SAVE VTR 700

PAGE 6
9
SAVE VTR 500
10
SAVE VTR 700
11
SAVE VTC 200
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
1. Stop the unit by disconnecting the mains.
2. Open the front hatch.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Close and lock the front hatch and connect the
unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Remove the front hatch and open side doors.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Close and lock the front hatch and connect the
unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Open the front hatch.
3. Remove old lters and insert new ones. Make sure
lters are not mixed up during the replacement process.
Supply and extract air lters may be dierent.
4. Close and lock the front hatch and connect the
unit to mains.
5. Reset the lter time.