SystemAir SAVE VTC 300 Installation And Service

Accessories
|
43
Fig. 16 Damper connection
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Configure the contactor switch that controls the dampers. Go to Output menu. Select DIGITAL tab. Select the digital
output to which the contactor is connected. Example if it is connected to DO3 on the connection board, then select
DIGITAL OUTPUT 3 and select signal type as Outdoor-/Exhaust Air Damper from the output type list.
9.6 Filters
The filters need to be replaced when polluted. New sets of filters, if possible, should be acquired directly from Systemair
to meet filter quality standards. If that is not possible, please contact your installer or wholesaler.
The filter type is labelled on the top of the filter
Component/product — Article number:
• MPVTC 300 G4 — 207039
• MPVTC 300 M5 — 207040
• MPVTC 300 F7 — 207041
• BFVTC 300 F7 — 207042
211464 | A001

SystemAir SAVE VTC 300 Specifications

General

Brand	SystemAir
Model	SAVE VTC 300
Category	Fan
Language	English