SystemBase C510xr - REMOTE MANAGEMENT VIA TERMINAL; C510 xr Network Command Reference

REMOTE MANAGEMENT
The C510xr / C520xr Codec can be configured
remotely by connecting a straight 9 Way D-Type
cable to the MGR IP port, and using the Standard
Windows Terminal Program. To configure more than
one unit at the same time, the user can connect
another straight 9 Way D-Type cable from the MGR
OP port of the first unit, to the MGR IP port of the
next unit, in a “Daisy Chain” manner. There are no
limitations on the number of codecs which can be
linked together for remote configuration purposes.
On initial connection, the Standard Windows
Terminal Program screen will be blank. The user
should then press the Enter key to clear the
command buffer.
Type “poll” followed by the serial number :-
poll 0108-001 < carriage return / enter >
0108-001>
A prompt of the actual serial number will appear on
the screen.
Type “help” for list of commands.
0108-001 >help
C510xr Network Commands, (c) Systembase
Limited
poll (8 digit serial number)
status (displays the codecs current status, /s option
for short)
set name (new patch name)
set patch (patch index)
set backup level (0..100)
set restore time (1..90)
set reserve (Off, On)
set aux (Off,
9600bps,
4800bps,
2400bps,
9600bps(alt),
4800bps(alt),
2400bps(alt),
Relay Mode)
set source (Analog, AES3)
set loopback (Off, On)
set x21 (APTX:3K7 Stereo 64Kbps,
APTX:7K5 Mono 64Kbps,
APTX:7K5 Stereo 128Kbps,
APTX:15K2 Mono 128Kbps,
APTX:12K2 Stereo 192Kbps,
APTX:22K5 Mono 192Kbps,
APTX:15K2 Stereo 256Kbps,
APTX:22K5 Stereo 384Kbps)
set password (Not Set (pin), Edit Lock (pin),
Full lock (pin))
set isdn (G711:3K2 Dual 64Kbps,
G722:7K5 Dual 64Kbps,
APTX:3K7 Stereo 64Kbps,
APTX:7K5 Mono 64Kbps,
APTX:7K5 Stereo 128Kbps,
APTX:15K2 Mono 128Kbps,
HIT-APTX:7K5 Stereo 128K,
HIT-APTX:15K2 Mono 128K)
set mode (ISDN Mode,
X21 Mode,
Backup Master,
Backup Slave,
Nailed ISDN)
set mixing (Off, On)
set priority (Bandwidth, Stereo Image)
set autohunt (Off, On)
set alarm (Sync Loss, Backup, Off)
dial (dials the current patch)
hang (hangs the current isdn call)
set rem add (channel) (destination number)
set rem sub (channel) (destination sub addr)
set loc sub (channel) (local sub address)
The Status command will display the following
information on the codec.
Page 17