T.E.L.L. EAG80 - 4.4 Weighing System Settings; 4.4.2 Weighing Element Settings; 4.4.5 Zero Point Adjustment; 4.4.6 Scale Calibration with Weights

Total no. of pages: 30
PAGE 19
Anleitung EAG80_26_00_2017_03_28_GB
Version 28.04.2017
4.4 WAAGE Waage
Waage


AUFLo
Display steps
⇑ ⇓
Stabe
Weighing elements basic settings
⇑ ⇓
nuLLp
Set scales to zero
⇑ ⇓
FACTO
Weight factor
⇑ ⇓
0-JUS
Zero point adjustment
⇑ ⇓
JUST
Scales adjustment with weights
⇑ ⇓
4.4.1 AuFLo
Auflo
Selection of display steps 0,01; 0,02; 0,05; 0,1; 0,2; 0,5; 1; 2; 5; 10; 20; 50
4.4.2 StAbE
Stabe
Basic settings of weighing elements , adjustment via key data (quantity / max load / mV/V)
StAbA quantity of connected weighing elements
LASt maximum load of connected weighing elements (see type plate of weighing element)
StAbS mV/V value of connected weighing element (see type plate of weighing element)
4.4.3 nuLLP
NULLP
Set scales to 0 when zero button is activated
4.4.4 Facto
FaCTO
Input of weight factor
4.4.5 0-JUS
0-jUs
0-point adjustment for better readjustment with high dead load
4.4.6 JUSt
JUST
Scales adjustment with weights
0-JuS 0-point adjustment
G-JuS Weight entry for adjustment