5. Electrical connection
The appliance is supplied with line cord and plug. Do not carry or pull the unit by the line cord or plug.
Protect the plug and the line cord from heat, oils and sharp edges.
Check that the voltage shown on the label of the unit corresponds to the voltage of the
mains supply. The person responsible for the installation must ensure that all electrical
connections are earthed according to the electrical regulations of the authority in the area.
Connect the unit only to power supplies with residual current circuit breaker (RCCD) with
sensitivity of 30mA (DIN VDE 0100T739). (earth leakage system)
The electrical supply cord connections of this unit are completely encased with epoxy resin
and cannot be replaced or repaired. In case of damage the unit has to be disposed of.
6. Operating Instructions
Check that the voltage shown on the label of the unit corresponds to the voltage of the
mains supply.
Always operate the appliance in water. Do not run dry as this may cause overheating of
pumps and damage the entire unit.
To Next Page
Loading...
Need help?
General
