Page 5
Need help? Visit
or call T-Mobile customer service at
T-Mobile 5G Gateway User Guide
Follow these recommendations to protect yourself and the Product from harm:
ż Use the Product only in upright position as shown in the Quick Start Guide
ż Do not insert any sharp object into the openings of the Product
ż Do not put the Product near a heat source
ż Avoid placing the Product in direct sunlight
ż Do not put the Product in damp or wet locations; for example, near a bathtub, washbowl,
kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Do not spill any liquid
on the Product
ż Do not touch the Product or its power adapter or cord with wet hands
ż Do not place the Product on an unstable surface or support
ż Do not place anything on top of the Product
ż Do not use liquid or aerosol cleaners; unplug the Product and use a soft, dry cloth for cleaning
ż When connecting a PC or other electronic device to the Product, make sure you use the right
cables and connect the device to the right port of the Product
ż Incorrect connections may damage the device and/or the Product
ż Do not open or try to open the Product
ż Opening or removing covers can expose you to dangerous high voltage points or other risks
ż Do not attempt to access, manipulate, insert foreign objects into, remanufacture, or immerse
or otherwise expose it to water
ż Do apply care to avoid accidental drops along with the Product
ż If the T-Mobile 5G Gateway is dropped—especially on a hard surface—or in the case of
suspected damage, contact your nearest T-Mobile service center for inspection
Follow these guidelines when using the T-Mobile 5G Gateway:
ż Connect the Product power adapter or cord to the right supply voltage (120V AC in USA)
ż Pay attention to the power load of the electrical outlet and possible extension cord
ż
ż
ż Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can
be fully inserted with no part of the blades exposed
ż Leave adequate space for heat dissipation to avoid any damage caused by overheating the
Product