Multiple Specimen Holder (E3945)
Divided into sections, the E3945 Multiple
Specimen Holder permits eight samples to be
tested simultaneously for quick comparisons.
Intended for nylon hosiery and lightweight
fabrics, the normal test load used with this table
is 125 or 250 grams. A template is provided as
a guide to cut specimens to the proper size.
NOTE: To mount samples, place each over its
mounting area with the narrow end toward the center.
Using the insertion tool, tuck the edges into the slots.
Fit the arms of the spider clamp plate into the slots
and smooth out any wrinkles. Mount the clamp plate
and tighten. Finally, draw all samples taut with the
clamp ring and tighten.
Figure 41
Figure 42
Figure 43
Figure 44
17 5135 / 5155 Operating Instructions ver 1.1
To Next Page
Loading...
