Taber 5135 - Wheel Refacing; Specimen Mounting

Wheel Refacing
Part No. Model Description
121102 S-11 Refacing Discs (4” diameter, 150 grit abrasive paper), 100 pc.
125777 ST-11 Refacing Stone (4” diameter x ¼” thick with ⅛” hole, opposing sides are
80 and 180 grit)
980250 250
Wheel Refacer [for use with all Rotary Abrasers]
128990 133-60 Single Point Diamond Tool for Wheel Refacer, 3/8” – 24 thread (for
980250 s/n 20041462 and later, and 980200-20)
125608 200-62 Multiple Point Diamond Tool for Wheel Refacer, 3/8” – 24 thread (for
980250 s/n 20041462 and later, and 980200-10)
Specimen Mounting
Part No. Model Description
125560 S-36 Specimen Mounting Cards – 4 ¼” square (one side coated w/pressure
sensitive adhesive, opposite w/test record form), 50 pcs.
129270 S-36-1 Specimen Mounting Cards – 4 ¼” round (same description as S-36), 50
pcs.
125558 S-37 Specimen Mounting Sheets – 4 ¼” square (both sides coated w/pressure
sensitive adhesive), 100 pcs.
129271 S-37-1 Specimen Mounting Sheets – 4 ¼” round (same description as S-37),
100 pcs.
120990 E100-125 Specimen Holder – 4 ¼” O.D. (complete with spring clutch, rubber pad,
nut and clamp plate)
125795 E100-101 Specimen Hold-down Ring, 4 17/64” I.D.
125796 E100-102 Specimen Hold-down Ring, 4 21/64” I.D.
121205 E100-10 Specimen Holder – 4 ¼” O.D. (transparent plastic)
121155 E140-14 Specimen Holder with Clamp Ring – With Center Screw (S) or without
Center Screw (NS)
121148 E140-15 Specimen Holder – Textile
121208 E140-18 Specimen Holder – Textile (rimmed)
121207 E140-19 Specimen Holder – “Drive Pin” Type
121206 E140-21 Specimen Holder – Threaded Ring (NEMA)
125604 E140-75 Specimen Holder – Rimmed
132725 Specimen Holder – Sliding Mount (permits testing of four 2” x 2” square
samples)
121241 E3945 Specimen Holder – Multiple Textile
121224 S-21 Extension Nut for ¼” to ½” Thick Materials (samples require 3/8”
diameter center hole)
132690 Arm Height Extension Kit, for Model 5135 Single Abraser – test
specimens up to 40mm (includes left & right arm height extenders and
set of 6 shims)
132705 Arm Height Extension Kit, for Model 5155 Dual Abraser – test specimens
up to 40mm (includes left & right arm height extenders and set of 6
shims)
121016 S-19 Rubber Pads for Specimen Holder (4 ¼” O.D.), each
49 5135 / 5155 Operating Instructions ver 1.1