WWW.TACTACAM.COM
GETTING TO KNOW YOUR TACTACAM
CHARGING & BATTERY INFORMATION
CAMERA BATTERY
Your camera and battery need to stay connected when operating.
DO NOT remove the battery from the camera when in use or your data will be lost.
On your Tactacam 4.0 and 3.0 there are 4 Green LED battery indicator lights. When
all 4 lights are illuminated the camera battery is full. As the battery levels decreases
the lights will begin to reduce in numbers till there is one LED light remaining. The last
battery level LED indicator light will begin to blink when the battery drops below 10%. If
the battery reaches 0% while recording, the camera saves the le and powers off.
MAXIMIZING BATTERY LIFE
Extreme cold temperatures can decrease battery life. To maximize battery life in cold conditions,
keep camera in a warm place prior to use. Protect the Rec/Power Button to prevent the camera
from accidentally turning on.
Note: (Tactacam Solo) the Green LED will blink fast when the battery reaches the nal 10% of life.
CHARGING TIME USB CORD WALL PLUG
The battery charges to 80% in approximately two hours and 100% in approximately
three hours when using Tactacam’s USB-compatible charger, Wall Charger for
Tactacam, or other USB charging adapter. Other chargers might charge at a slower
rate.
WARNING: Using a wall charger other than a Tactacam’s Wall Charger can damage the Tactacam’s
camera battery and could result in re or leakage. Only use chargers marked: Output 5V 1A. If you
do not know the voltage and current of your charger, use the included USB cable to charge the
camera from your computer.
CHARGING TIME USB CORD COMPUTER
The battery charges to 80% in approximately three hours and 100% in approximately
four hours. When using Tactacam’s USB cord connected to a computer for charging,
it is best to have the camera powered off. Charge times may vary depending on your
computer’s USB output settings.
To Next Page
Loading...
Need help?
General
