Instruction and Operating Manual
TA-U1...U280
Misprints and technical changes reserved
6
2. General
After production all devices are checked and are ran a 200 hours continuous test. Before delivering the devi-
ces are checked again. By this proceedure we want to ensure that only flaw less devices are delivered.
In normal case there are no failures expected if the drive has been adjusted correctly and the issues of the
operating manual have been followed.
If, in spite of this, a failure occurs, get in contact with one of our agents or contact us directly.
2.1 Name Plate
The name plate is placed on the right side of the device. Make sure that the device is not damaged by transport
before installing it. Compare the delivered parts (look at name plate) with the bill of delivery.
2.2 Expected Readers of this Manual
This operating manual is for users which are qualified to handle this device.
2.3 Liability
Defects within the device should not be repaired by the user. Nonauthorized repairs leads to loss of warranty.
TAE is not liable if any manipulations have been made, for example, attempts to repair.
If there is any doubt about the cause of failure or possibility of repairing, please contact TAE to avoid further damage
to the device or motor.
Type:
Part-No.:
Volts Input: VAC
Amps Input: A
Phase, Freq.: 3 Ph, 50/60 Hz
Power Output: kW
Amps Output: A
Starting Amps: A
Ambient temp.: 0-40 °C
Serial No.:
Date:
www.tae-antriebstechnik.de
Made in Germany
16.04.08
1037
TA-U6HT
19107-1G31C0
300-480
11,5
6,0
15,0
22,5
Type
Line input
Line frequency
Rated output current
mbient temperature
Date of production
Part number
Mains
Power Output
Current overload
Seriens number
TAE Antriebstechnik
Raiffeisenstrasse 10
D-61250 Usingen
To Next Page
Loading...
Need help?
General
