What to do if LED indicators are not lighting up properly during sensor test on tae TA-U65 DC Drives?
If the LED indicators on your tae DC Drives aren't lighting up correctly during the sensor test, make sure the motor is properly connected. Also, verify that the control voltage is on.
General safety advice for handling electrical equipment.
Nominal data for drive models at 8 kHz switch frequency.
Principle diagram for TA-U1 to TA-U6 drive models.
Principle diagram for TA-U8 to TA-U15 drive models.
Principle diagram for TA-U22 to TA-U90 drive models.
Principle diagram for the TA-U110 drive model.
Principle diagram for the TA-U150 drive model.
Principle diagram for TA-U200 to TA-U280 drive models.
General guidance and safety advice for installing the drive.
Diagrams showing main power input and output connections.
Wiring details for the control board and alternative PLC control.
Wiring diagrams for various encoder types.
Wiring for analog input/output and digital I/O connections.
Safety instructions for operating the drive.
Overview of error codes (F0-F9, E1-E3) and status indicators.
Detailed descriptions of specific fault codes and their causes.
To Next Page
General