Instruction and Operating Manual
TA-U1...U280
Misprints and technical changes reserved
8
3.1.3 Norms and Directives
The designated product is in conformity with the provisions of the following European Directives.
2004/ 108/EEC EMC directive
Directive on the approximation of the laws of the Member States relating to electromagnetic compability.
(Amended by Directives 93/68/EEC)
According to these criteria, our products are classified as follows:
- Product components: Parts from suppliers which are inoperative on their own.
- Product distribution: Not commonly available, sold to qualified persons.
The law states that an EC-declaration of conformity, as well as a CE-marking, is not required for such components.
In order to meet the requirements of the EMC-directive we supply the following:
- Productrelated documents which describe the interference radiation of our products. This information will enable
the user to provide all necessary steps to meet the EMC-requirements during planning and installation.
- EMC-specific components such as filters, chokes, shielded wiring, metal enclosures and others are available from
TAE. TAE will furthermore provide specific technical information concerning the proper use of such components
for their products in order to meet the requirements of the harmonized standards.
It is the users responsibility to carry out our instructions and to use adequate provisions. The user is also responsible
that his machine and installation meets the requirements of the EMC-standards.
Based on the EMC directive and its corresponding standards, we have carried out extensive measurements at our
premises. These tests have included our complete product line. With the use of filters and proper wiring all our
products meet the requirements of the EMC Product standard of electrical power drive systems. These directives and
recommendation for the use of electronic equipment are based on the following standards:
73/23/EWG bzw. 2006/95/EG Low Voltage Directive
Council Directive on the approximation of the laws of the Member States relating to all electrical equipment designed
for use within certain voltages limits. (Amended by Directives 93/68/EEC)
Using a QM system, TAE is watching all steps from development to production of the device. So all norms and direc-
tives can be fulfilled referring to this aspect of safety.
CE-marking
The CE-marking indicates the conformity of the the TA-BL drive to the european norms and directives.
The fulfillment of the norms and directives is only guaranteed if:
.....The regulator is fitted out with a internal or external EMC filter which is tested by the manufacturer.
.....You exactly follow the Instructions for installation (refer to Chapter 4.1).
Improper installation can lead to exceeding the maximum limits of EMC and to a malfunction of devices of other
manufacturers.
EN 60204-1 (VDE 0113: 1992-1) Electrical equipment of machines
EN 60529:1991 (VDE 0470 Part 1) Protection Provided by Enclosures
DIN EN-50178 (VDE 0160:1994-11) Electronic equipment for use in Electrical Power installations
DIN VDE 0100 Erection of Power Installations
DIN VDE 0110 Dimensioning of Clearance and Creepage distances
DIN 40050 IP-International Protections
EN 61800-3 EMC Product standard of electrical power drive systems
To Next Page
Loading...
Need help?
General
