Step 10. Your meter has four reminder
alarms. The meter will display “OFF” and
“AL.1 ”. If you don’t want to set an alarm,
press S button to skip this step. Or press
M button to select “On”, then press S
button.
With the hour/minute flashing in
sequence, press M button to select the
correct hour/minute. Press S button and
go to the next alarm setting.
NOTICE
When the alarm beeps, press M button
to switch it off. Otherwise, it will beep for
2 minutes then switch off
21
NOTE
The time, date and unit of measurement •
in the setting mode. Therefore, when
test or blood pressure test, those glucose
possible to be changed.
*3: The milligram per deciliter (mg/dL) is the standard unit in •
the United States. The millimole per liter (mmol/L) is the stan-
dard unit in Canada. Use of the wrong unit of measurement may
cause you to misinterpret your blood glucose level, and may
lead to incorrect treatment.
While the monitor is in the setting mode, if no button is pressed
•
for 3 minutes, the monitor will turn off automatically.
You may also press the •
button any time to turn off the moni-
tor and exit the Setting Mode.
can ONLY be changed
you perform blood
parameters are not
“ ”
22
BLOOD GLUCOSE MEASUREMENT
Severe dehydration and excessive water loss may cause
•
false low results. If you believe you are suffering from severe
dehydration, consult a healthcare professional immediately.
If you get your blood glucose results lower or higher than
•
usual, and do not have symptoms, first
repeat the test. If you
have symptoms or continue to get results higher or lower than
usual, follow the treatment advice of your healthcare profes-
sional.
Use only capillary whole blood sample to test your blood glu-•
cose. Using other substances will cause wrong results.
If you are experiencing symptoms that are not consistent with•
your blood glucose test results and you have followed all in-
structions described in this owner’s manual, call your health
-
care professional.
Inaccurate results may occur in severely hypotensive individu-
•
als or patients in shock. Inaccurate low results may occur in
individuals experiencing a hyperglycemic-hyperosmolar state,
with or without ketosis.
Please refer to your test strip package insert for additional im-•
portant information.
Important Information
KIPTRACK
To Next Page
Loading...
