Tailift TPR1230 - Page 3

0-2
Section Content page
4.2.2 The movement of the machine …………………………………………
4-2
4.2.3 The order to pack …………………………………………………………...
4-3
4.3 Installation of the machine ………………………………………………
4-3
4.3.1 Have the machine set onto the fastening bolts of the crate base ……….
4-3
4.3.2 Level adjusting. …………………………………………………………….
4-4
4.3.3 The installation of the electricity ………………………………………
4-4
4.4 The test after installation ………………………………………
4-4
4.5 The procedure for dismantling the machine …………………………..
4-4
CHAPTER 5 Operation
5.1 A brief introduction to the relevant operation hardware ……………….
5-1
5.1.1 (For TPR-1230, TPR-1230H) ………………………………………..
5-1
5.1.2 (For TPR-1600H, TPR-2000H) ……………………………………...
5-3
5.1.3 Safty protective device (suit every model)…………………………….…….
5-5
5.2 Instruction to switches …………………………………………………..
5-6
5.2.1 (For TPR-1230, TPR-1230H) …………………………………………
5-6
5.2.2 (For TPR-1600H, TPR-2000H) …………………………………………
5-8
5.3
Installation of the clamp（work piece）
……………………………….
5-9
5.3.1 General …………………………………………………………………….
5-9
5.3.2 Introduction of the vise and the clamping of the work piece …………
5-9
5.3.3 Universal clamp and the clamping of the work piece ………………..
5-10
5.4 Installation and change of the drilling bit ……………………………
5-11
5.4.1 The assembly and disassembly of the drilling head and clamp ………
5-11
5.4.2 The assembly and disassembly of the straight handle drill bit ………..
5-13
5.5 Power on and off …………………………………………………………...
5-13
5.5.1 Power on …………………………………………………………………...
5-13
5.5.2 Power off …………………………………………………………………...
5-13
5.6 Work light ………………………………………………………………….
5-14
5.7 Cutting fluids ……………………………………………………………...
5-14
5.8 Elevating the arm …………………………………………………………...
5-14
5.9 Rotate the Gearbox right or leftwards …………………………………
5-15
5.9.1
(For TPR-1230,TPR-1230H）
…………………………………..
5-15
5.9.2
For TPR-1600H, TPR-2000H）
………………………………………
5-15
5.10 Rotate the arm forward or backwards …………………………………
5-16
5.10.1 (For TPR-1230,TPR-1230H)………………………………………………..
5-16
5.10.2 (For TPR-1600H, TPR-2000H)……………………………………………...
5-16
5.11 Change the spindle speed ……………………………………………….
5-17
5.11.1 (For TPR-1230,TPR-1230H) ………………………………………
5-17
5.11.2 (For TPR-1600H, TPR-2000H) ………………………………………
5-20