What to do if the drill bit breaks on a Tailift TPR720A Drill?
If the drill bit breaks, immediately stop the spindle, press the emergency stop button, and push the gearbox backwards. Use pliers to pinch the end of the broken bit, then rotate it counter-clockwise while pulling upwards to remove it.
What happens if a person is entangled in a Tailift Drill?
If a person becomes entangled, immediately press the emergency stop button and power off the machine. Switch the speed change lever to the highest gear. Rotate the spindle counter-clockwise by hand until the person is free from the machine.
Why does the spindle overload and the fuse burn out on my Tailift TPR720A?
If the spindle overloads and the fuse burns out, it could be because the drill bit is too big, or the feed rate is too fast. Replace the fuse and open/close the control box. Power on.
What to do if the screw tap breaks in a Tailift TPR720A Drill?
If the screw tap breaks, stop the spindle and press the emergency stop button. Use a thread releaser to rotate the screw tap counter-clockwise until it comes out. If you cannot pull it out, consider melting it out with EDM or declare the part unusable.
To Next Page
General