Tailift TPR720A - Replace the Cutting Fluids

7-6
7.3 Replace the cutting fluids.
It requires only one person to do it. Please power off and press down the emergent stop
power button before carrying out the job.
Instruction to the relevant parts.
1. Oil filler points It is the open where the cutting fluids are added when it
recycles, or isn’t sufficient or needs to be replaced.
2. Oil drain outlet It is the outlet where the cutting fluids are drained.
The following is the Tool to replace the cutting fluids.
The cutting fluids 30L
Container and spanner
The steps：
：：
：
1.
Power off.
2.
Press down the emergent stop button.
3.
Place a container under the oil drain outlet.
4.
Release the drain plug using a spanner.
5.
After draining, tape the plug with a sheet of band and tighten it back to the drain
outlet.
6.
Refill the cutting fluids through the oil filler inlet to the level under 5 mm under the
oil filter.