Tailift TPR720A - The Assembly and Disassembly of the Work Table; Cutting Fluids for All Kinds of Material

5-32
5.15 The assembly and disassembly of the work table.
Disassemble it as follows:
1. Release 1, as shown in the picture, using a
spanner. That’s to move the spanner counter
clockwise.
2. Apply the above to the other side.
Assembly it as follows:
1. Clean the debris from the base with a
metal brush.
2. Clean the worktable and the base with
rags.
3. Place T shape Bolts into the T shape
chamfer of the base.
4. Tighten the nuts.
5.16 Cutting fluids for all kinds of material.
Soft steel
crude oil、
、、
、animal fat
Mild steel
crude oil、
、、
、animal fat
High carbon steel
crude oil、
、、
、animal fat
Stainless steel
crude oil、
、、
、animal fat
Manganese steel
crude oil、
、、
、animal fat
Cast iron Without
Malleable cast iron Crude oil
Brass, bronze Kerosene
Aluminum and alloy Kerosene
Precaution
When cutting fluids is not applied, Having the turning speed and the feed rate
reduced is the only way to extend the tool life. If cutting fluids leaks or injects
to the aisle, please clean it immediately from the floor.