1-2
1.3 Precautions for operation:
(1)
Please don’t remove any protection guard or any safety installation.
(2)
Please don’t remove or alter any location of the limit switches, restraint blocks or
interlocking mechanisms.
(3)
Don’t touch any switch with wet hand.
(4)
Please don’t put any part of your body on the moving parts of the machine or near
to them.
(5)
The operation person have better no long hair, if it is impossible, please have it
coiled in a topknot and wear a safety helmet.
(6)
Please wear no hand ring, watch, pearls or loose clothes. Operation should wear a
safety clothes.
(7)
Please wear no slippery shoes while operating.
(8)
Wearing gloves is needed when loading and unloading material.
(9)
Only one person is allowed to operate the machine.
(10)
While operation, Debris may fly off. So please wear a protective mask to prevent
from being injured.
(11)
Please power off after work.
(12)
Please wear a gauze mask if you are working, using cutting fluids.
(13)
Please don’t use the machine in a explosive environment.
(14)
A risk of being squeezed is composed when the gearbox and the arm are d
or the spindle is descending to the worktable. (The arm screw moves at a low speed
of 0.8 m/min.)
(15)
Operator should stand in front of the machine. That’s the operation position.
1.4
Precautions for checking and maintenance.
(1)
Please power off first before performing maintenance or checking job.
(2)
Only have authorized electric technician carry out maintenance or checking job
when Power-on is needed in it
(3)
Please power off after work.
(4)
Adding or replacing hydraulic oil or lubricant, Please use Tailift recommended oil
type or its equivalent. For details, please refer to the chapter 7.
(5)
Basically, only one person is needed to serve. If more than one person is called for,
Good communications is required.
(6)
Please power off first before getting rid of the iron filings or cleaning the machine.
To Next Page
Loading...