CNC-110A Series C-03/C-13 User's manual
13
έᚊཝҋજѣࢨΦ
TAILY AUTOMATION CO.,LTD.
11.1.Requirement and Safety precautions
1. The controller should be operated in an environment that is protected from moisture, corrosive
gases, or liquid, and free from airborne dust, metallic particles, and magnetic noise.
2. Make sure that the power source supplies the correct voltage and is capable of supplying the
required current to the controllers.
3. Do not connect or disconnect wires and connectors while power is applied to the controller.
4. Make sure the machine and controllers are properly grounded.
5. Make sure that the leads and connectors are connected correctly.
6. Normally operate under 5
℃
~ 50
℃
environment, over 40
℃
should perform under good
ventilation, avoid heating.
11.2.Periodically maintain
The following parts must be maintained or changed periodically as list below. If any part is found
faulty, it must be changed immediately even when it has not yet reached the end of its life, which
depends on the operating method and environmental condition. For parts replacement, please
contact your sales representative.
NO Part name Life guideline
1
Winding spindles Turns counter
CNTB-03B/03C
2 years
2
RELAY
(
RY-BLY
board, it used to switching the winding
direction)
100,000 times
3
Carbon
BRUSH
in the DC motor
1 years
To Next Page
Loading...
Need help?
General
