10 T2020 Operator's Manual
1 Accessing The Call Queue
The call queue can be accessed through the Function Menu Entry mode. This is the
same mode as that used to alter the user options.
- To enter this mode, press the key. The last item viewed previously will
appear in the display. Scroll the items through the display by pressing the
and keys.
- Once in this mode, scroll through the item list and select "CALL QUE".
- Pressing the key when "CALL QUE" is being displayed will let you
access the Call Queue, but only if the queue is not empty.
- In Call Queue Entry mode, the display will show the current entry number and
the total number of entries in the list. An example of the display would be "CL
01/02" which indicates that the current entry is entry number one, with a total
of two entries in the queue. The and arrow keys can be used to
scroll through the list of entries and the key can be used to delete the
entry from the queue.
- Pressing the key will then show the caller identity of this entry. Again,
the and arrow keys can be used to scroll through the list of entries
and the key can be used to delete the entry from the queue.
- Pressing the key again when the caller identity of the entry is being
displayed will initiate the call back and automatically remove that entry from
the queue. Note that the call back sequence is based on the caller identity.
2 Exiting The Call Queue
Pressing any mode key while in the Call Queue will initialise the respective mode
and therefore will take the radio out of the Call Queue Entry mode. This includes
the key.
When deleting entries and making call backs, if the call queue becomes empty, the
radio will automatically exit from the Call Queue Entry mode and go back into the
Function Menu Entry mode.
To Next Page
Loading...
Need help?
General
