T2020 Operator's Manual 9
4 Your T2020 may be programmed to queue incoming calls. If this feature is enabled,
the caller's identity will be put on the queue after the ringing stops. All other call
indicators will be cleared when the received call has been queued. (Refer to the
section on Call Queuing for more information.)
5 If the call was not queued and you are still unable to answer the call, the radio will
indicate that a call was received in your absence by leaving the red !
!!
! indicator
flashing.
6 If you do not wish to answer a call, the ringing may be cancelled at any time by
pressing any of the front panel keys. (The function associated with the key you
press will not be invoked.) Note that if the caller's identity was displayed and the
call was still not answered, pressing the key will clear the call and initiate an
'immediate call back' to the caller.
7 If you are one of the recipients of a group call, your radio will only sound a single
sequence of the ringing tone, burr,burr. The caller will then broadcast his message
to all members of your group.
Advanced User Operations
Repeater Talkaround
Repeater talkaround is a programable option that allows the T2020 to transmit and
receive in simplex on the repeater receive frequency of the current channel. This feature
can be used to talk to other participants on a repeater channel without the use of the actual
repeater, for example when you are out of reach of the repeater.
1 Press the key for longer than 1 second.
2The ! should now be flashing which indicates that the T2020 is now in the
repeater talk around mode.
Call Queuing (Selcall Option Fitted)
This feature will enable the storing of up to 10 caller identities. Consult your Tait dealer
to find out if this feature has been enabled for your radio.
To Next Page
Loading...
Need help?
General
