12 T2020 Operator's Manual
1 Activating Call Diversion Mode
The Call Diversion "switch" can be accessed through the Function Menu Entry
mode. This is the same mode used to alter the user options.
- To enter this mode, press the key. The last item viewed previously will
appear in the display. Scroll the items through the display by pressing the
and keys.
- Once in Function Menu Entry mode, scroll through the function list and select
"DIVERT".
- Pressing the key while "DIVERT" is being displayed will initiate the call
diversion set-up process.
- On entry into the set-up procedure, the display will flash the last selected
diversion call type: this may be Selcall or DTMF. Use the and
arrow keys to toggle between the two options. Note that if the DTMF option
has not been fitted on the radio, the DTMF call type will not be an option.
- Pressing the key will confirm the call type selected and display the last
selected sequence if it was still valid. If the last selected sequence was no
longer valid, the displayed sequence will be the default sequence.
- If another sequence is required, the numeric keypad can be used to enter the
new diversion sequence. Note that the correct sequence length must be entered
(consult your Tait dealer for more information on this). Pressing the key
will confirm the diversion sequence and put the radio into Call Diversion
mode.
2 Exiting Call Diversion Set-up/Mode
At any stage of the call diversion set-up process, any mode key-presses will
initialise the respective mode and therefore take the radio out of the Call Diversion
Set-up/Mode. This includes the key.
3 Receiving A Call During Call Diversion
When a standard incoming call is received by the radio in Call Diversion mode, the
programmed auto-acknowledge sequence will be transmitted as for a normal call,
but the programmed Diversion Status will be transmitted instead of the normal
acknowledge status to inform the caller that the call has been diverted.
To Next Page
Loading...
Need help?
General
