Tait TB9300 - Page 50

50 Operation TB9300 Installation and Operation Manual
© Tait International Limited April 2024
Rear View
The indicator LEDs on the rear of the reciter are on the Ethernet connector.
These LEDs provide the following information about the state of the
reciter:
Series 2
10Base-T Ethernet The green Ethernet connector LED will flash and the amber LED will be
off if the connection is running at 10 Mbits/s.
100Base-T Ethernet The green Ethernet connector LED will flash and the amber connector will
be on if the connection is running at 100 Mbits/s.
Series 1
10Base-T Ethernet The green Ethernet connector LED will be on and the amber LED will be
off if the connection is running at 10 Mbits/s.
100Base-T Ethernet The green Ethernet connector LED will be off and the amber connector will
be on if the connection is running at 100 Mbits/s.
Figure 3.3 Indicator LEDs on the rear of the reciter
b
10Base-T Ethernet Connector LED (green)
c
100Base-T Ethernet Connector LED (amber)
b
c