TM8100 Mobile Radio Service Manual Disassembly and Re-assembly of Radio 147
May 2004 © Tait Electronics Limited
Close Radio Body Secure the lid and cover of the radio body as follows:
1. If an options board is installed in the lid of the radio body,
reconnect the options loom to the internal options connector on
the main board. This is best done with the lid placed next to the
chassis as shown in Figure 6.7.
2. Place the lid in position on the chassis. Ensure that the main seal
in the lid is properly seated.
3. Screw in by hand the four screws that secure the lid. Ensure that
the screws start easily and are not cross-threaded. Then use a Torx
T20 torque-driver to tighten the screws to 2.5 N
·m (22 lbf·in).
4. Fit the cover of the radio body.
5. Continue with the servicing procedure detailed in Subsection 5.2
(on page 109).
To Next Page
Loading...
Need help?
General
