Basic Operation 11
Basic Operation
This section describes the basic operation of your radio,
including turning the radio on and off, adjusting volume,
selecting channels, making calls and receiving calls.
Turning the
Radio On
and Off
A long press of the on/off key turns the radio either
on or off. When the radio is first turned on, the red,
green and amber LEDs flash briefly and the radio gives
two short beeps.
Adjusting
the Volume
Rotate the volume control clockwise to increase the
speaker volume and counterclockwise to decrease the
volume. The volume control also changes the volume
level of the radio’s audible indicators.
Selecting a
Channel
Use the channel selection keys or to scroll
through the channel list until the channel you want
is displayed.
Making a
Call
1. Select the required channel or group using the chan-
nel selection keys or .
2. Check the green LED.
If the green LED is glowing, the channel is busy and
you cannot transmit.
3. Once the channel is clear (the green LED is off), lift
the microphone off the microphone clip.
4. Hold the microphone about 5cm (2 inches) from your
mouth and press the PTT key to transmit.
5. Speak clearly into the microphone and release the
PTT key when you have finished talking.
Note: You cannot change channels while
transmitting.
To Next Page
Loading...
Need help?
General
