Tait TM9300 DMR User Manual

TM9300/TM9400 Installation Guide Installation Options 17
© Tait Limited December 2015
2.5 Desktop Installation
The TMAA13 power supply enables you to use a mobile radio as a desktop
radio. The TMAA13 operates on an input voltage of 100–130VAC or
200–250VAC, depending on the model, and can be used with both 30-
50W and 25W radios. The mobile radio can be installed at a distance from
the power supply, or it can be mounted on top of the power supply using a
plinth. The following diagram shows the components included in each kit.
Refer to the TMAA13 Power Supplies User’s Guide (MMZ-00002-xx) for
full details.
Tait strongly recommends to use one TMAA13 power supply for each
radio. This prevents any issues caused by simultaneous transmissions.
25W
Power Supply Kit
TMAA13
power supplymains cable
Plinth Kit
TMAA03-12: 30-50W radios
TMAA03-09: 25W radios
power cable
8.2ft (2.5m)
3 x screws
3 x washers
microphone clip
4 thumb screws plinth
U-cradle Kit
TMAA03-13: 30-50W radios
TMAA03-06: 25W radios
4 thumb screws
2 x screws
microphone clip
power cable
1ft (300mm)
U-cradle

Tait TM9300 DMR Specifications

General

Channel Spacing	12.5 kHz, 25 kHz
Operating Temperature	-30°C to +60°C
IP Rating	IP54
Frequency Bands	VHF, UHF
Bluetooth	Yes
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz
Channel Capacity	2000 channels
Operating Modes	Analog
GPS	Optional
Channels	2000
Modulation	4FSK