4
Chassis engraving will void warranty
Warning: Engraving the chassis of your partable radio can
significantly reduce its mechanical strength and will void any
warranty. If the chassis has been engraved, it must
be replaced.
Copyright and trademarks
All information contained in this manual is the property of
Tait Electronics Limited. All rights reserved. This manual may
not, in whole or in part, be copied, photocopied, reproduced,
translated, stored, or reduced to any electronic medium or
machine-readable form, without prior written permission
from Tait Electronics Limited.
The word TAIT and the TAIT logo are trademarks of Tait
Electronics Limited.
All trade names referenced are the service mark, trademark
or registered trademark of the respective manufacturers.
Disclaimer
There are no warranties extended or granted by this manual.
Tait Electronics Limited accepts no responsibility for damage
arising from use of the information contained in the manual
or of the equipment and software it describes. It is the
responsibility of the user to ensure that use of such informa-
tion, equipment and software complies with the laws, rules
and regulations of the applicable jurisdictions.
Enquiries and comments
If you have any enquiries regarding this manual, or any
comments, suggestions and notifications of errors, please
contact Technical Support.
To Next Page
Loading...
Need help?
General