Making and receiving different types of calls 47
3 Enter a new message using the keypad (see “Entering a
message” on page 47)
OR
Press an arrow key to begin editing an existing message,
then proceed in the same way as for entering a
new message.
4 Short press the menu key. The message,
ENTER ID will be
displayed, along with the receiver’s identity for the last
SDM transmission.
5 Short press the menu key again to send the message
using the existing ID.
OR
Enter a new ID using the keypad if you are calling a differ-
ent radio (the receiver’s identity must be eight characters
long), then short press the menu key to send.
Note: Once the message has been sent, the radio will return
to the message entry mode in preparation for sending
another message.
6 Long press the menu key to exit menu mode.
Entering a message
A text messages can contain up to 32 characters. See “Using
the keypad to enter text” on page 21.
To Next Page
Loading...
