Takagi GS-2000W-AU - CONNECTION OF REMOTE CONTROLLER WIRING TO THE WATER HEATER

16
CONNECTION OF REMOTE CONTROLLER WIRING
TO THE WATER HEATER
1. Turn o the power supply to the water heater.
2. Remove the front cover from the water heater. There are 3 screws on the front cover.
3. Put the remote wires through the hole on the boom of the unit’s casing.
4. Remove the plasc cover and connect the remote control wires to the remote terminals directly.
(There is no polarity in the terminaons.)
*DO NOT jump or short-circuit wires as it will damage the computer.
5. Replace the plasc cover and the front cover. Then connect the power plug.
1 2 3 4 5 6 7 8
PL A S T IC
CO V E R
RE MO T E CO N TR OL
CA BL E
RE M O T E C O N TR O L
TE R M I NA L
RE M O V E T H E P L A S TI C C OV E R
AN D C ON N E C T T O TE R M I NA L S
DI R E C TL Y B EH I N D T H E CO V E R
REMOTE CONTROLLER – CABLE CONNECTIONS
Put the remote wires through the
hole on the boom of the unit’s
casing.
1 2 3 4 5 6 7 8
TYPICAL CABLE LAYOUT
FC100-AU3-TP SC100-AU3-TP
MC100-AU3-TP