EasyManuals Logo

Takagi GS-2000W-AU User Manual

Takagi GS-2000W-AU
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
FREEZE PREVENTION
This unit comes equipped with heaters that prevent the unit from freezing. For this freeze prevenon
system to operate, there has to be electrical power to the unit. The freeze prevenon devices will not
work if the electrical power source is disconnected. The unit has been rated for temperatures down to
-15 °C in a wind free environment. Do not install the water heater in an area with extremely cold weather.
CAUTION
The pipe heaters are located on the Water Heater only. Any hot or cold water pipes located
outside of the unit will not be protected. Properly protect and insulate these pipes from
freezing.
WINTER SHUTDOWN
If you will not be using your heater for a long period of me or if the temperatures will drop below -15 °C
with the wind chill factor, turn o your heater and drain the unit of water. This will keep your unit from
freezing and being damaged.
Followtheseinstruconscarefully:
Gas
Cold
Hot
Drain
plug
Power
supply
Manual
water valve
Manual
gas valve
1. Close the manual gas shut o valve.
2. Turn o the power supply to the water heater.
3. Close the manual water shut o valve located on the water
supply line.
4. Open all hot water taps in the house. (Bathroom, kitchen,
laundry room, etc.). When the water ow has ceased, close
all hot water taps.
5. Have a bucket or pan to catch the water from the units
drain plugs. Unscrew the drain plugs to drain all the water
out of the unit.
6. Wait a few minutes to ensure all water has completely
drained from unit.
7. Securely screw the drain plugs back into place.
Hand-ghtenonly.
When it is again safe to use the water heater:
Make sure all hot water taps are closed and the drain plugs are securely aached.
Purge the water line of debris.
Turn on the manual water control valve located on the water supply line.
Open all the hot water taps to verify water ows to the taps. Close hot water taps.
Turn on the manual gas control valve located on the gas supply line.
Turn on the power supply to the Water Heater.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Takagi GS-2000W-AU and is the answer not in the manual?

Takagi GS-2000W-AU Specifications

General IconGeneral
BrandTakagi
ModelGS-2000W-AU
CategoryWater Heater
LanguageEnglish

Related product manuals