To Next Page

To Previous Page

INSTALLATION

The water heater requires careful and correct installaon to ensure safe and ecient operaon. This man-

ual must be followed exactly. Read the “SAFETY GUIDELINES” (p.6) and the “IMPORTANT” (p.2) secons at

the beginning of this manual.

CONFIRM THE APPLIANCE SUITABILITY

Check the gas type label and the rang plate for the correct gas type, gas pressure, water pressure and

electrical rang for your applicaon. Do not install this unit if these requirements can’t be met.

Gas Type Label

Posion on Cabinet

Rang Label

Posion on Cabinet

CAUTION

• This equipment is not suitable for pool or spa heang.

• Water hardness may aect the water heater. It may be damaged.

• It is important that the water heater is installed in water condions that are suitable for

its ecient, long use.

• This is a water heang apparatus only and the nal quality of water delivered is dependent

upon the quality of water supplied to this system.

• The connecon, aachment, integraon or general associaon of other equipment or

parts not specied by the water heater which either directly or indirectly aect the

operaon or performance of this equipment – could void the warranty.

• The manifold pressure is preset at the factory. It is computer controlled and should not need

adjustment.

• Occupants are to be advised of any inconveniences which could occur such as disconnecon of services.

• The installer must follow the electrical earthing procedure outlined in AS3500.4 before cung or

uncoupling exisng metallic pipework.

• It should be as close as praccal to the hot water outlets to minimise heat loss and cost.

• The water heater does not require a reproof back plate if installed on mber wall.

Takagi GS-2000W-AU User Manual

Questions and Answers: