Takagi T-H3M-DV - ADDTIONAL FEATURES; Information mode; Unit conversion mode

39 Page
Operation Screenonthecontroller
1.
Inlet water temperature will be displayed on the
controller by pressing the "INFO"button.
2.
Outlet water temperature will be displayed on the
controller by pressing the "INFO"button.
3.
Water flow rate, in gpm, will be displayed on the
controller by pressing the "INFO"button.
4.
Press the "INFO" button to finish information mode.
Inlet water temperature
(EX.: 60 °F)
Outlet water temperature
(EX.: 120 °F)
Water flow
(EX.: 3.5 GPM)
-Informaon mode-
-Unit conversion mode-
When the water heater is connected with the remote controller, the temperature
controller will not operate temperature settings, as only work for the information
mode (Indoor models only).
Operation Screenonthecontroller
1.
Press the "ON/OFF" button on the controller in
order to turn the controller on.
2.
When ON, the orange LED is lit.
3.
The previous set temperature will be displayed on
the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 100 °F)
(EX.: 38 °C)
ADDTIONAL FEATURES
You can get some information about the water heater condition by pressing the "INFO" button. For more
information, follow the procedures below:
The controller display information can be changed from English Units to S.I. / metric units.
Please follow the procedures below:
Normal Operaon
Owner's Guide