To Next PageTo Next Page
Need help?Do you have a question about the Takagi T-M1 and is the answer not in the manual?
General| Flow Rate | Up to 6.6 GPM |
|---|---|
| Weight | 38 lbs |
| Energy Factor | 0.82 |
| Condensing | No |
| Maximum Flow Rate | 6.6 GPM |
| Energy Efficiency | 82% |
| Maximum BTU Input | 140, 000 BTU/hr |
| Type | Tankless |
| Fuel Type | Natural Gas |
| Dimensions | 14.5 x 26 x 10 inches |
| Category | Residential |
| Voltage | 120 V |
| Dimensions (W x H x D) | 14.5 x 26 x 10 inches |
| Venting | Stainless Steel |
| Warranty | 5 years parts |
| Heating Capacity | 140, 000 BTU/hr |
Specifies the minimum and maximum input capacity for natural gas.
Specifies the minimum and maximum input capacity for LPG.
Details the required gas connection size and type.
Details the required water connection size and type.
Specifies the minimum and maximum water pressure limits.
Defines the acceptable pressure range for natural gas inlet.
Defines the acceptable pressure range for LP gas inlet.
Lists the manifold pressure for natural gas and propane.
States the overall weight of the water heater.
Provides the physical dimensions of the water heater.
Specifies the ignition type used by the water heater.
Details the required electrical supply voltage and frequency.
General installation considerations and precautions for gas water heaters.
Lists included accessories and checks for completeness.
Specific requirements and clearances for outdoor installation.
Specific requirements and clearances for indoor installation.
Guidelines for ensuring adequate combustion air for the unit.
General principles and warnings for appliance venting.
Requirements for the Category III approved exhaust vent system.
Guidelines for locating and installing the vent terminator.
Table detailing natural gas pipe sizing based on length and capacity.
Table detailing propane gas pipe sizing based on length and capacity.
Step-by-step guide for draining the unit and cleaning the filter.
Troubleshooting steps when the unit fails to start.
Specifics and warnings related to using the T-M1 for space heating.
Diagram and considerations for combined domestic and space heating systems.
Description of the remote controller for temperature adjustment and diagnostics.
Information on the wall vent terminator for Category III venting.
Details on the vent damper to prevent backflow and freezing.
Description of the outdoor vent cap for protection against debris and weather.
Information on the controller for managing multiple T-M1 units.
