Takagi T-K1S User Manual

23
Optional Items
1. TK-RE02 Temperature Remote Controller
The TK-RE02 Temperature
Remote Controller has two
functions. It allows the output
temperature from the T-K2 to be
adjusted within the range of 99
°F to 176 °F, and it also works
as a diagnostic tool that will give a concise error
code whenever there is a problem with the unit.
The temperature options are 99°F, 100°F, 102°F,
104°F, 106°F, 108°F, 109°F, 111°F, 113°F,
115°F, 117°F, 122°F, 131°F, 140°F, 158°F, and
167°F or 176°F. See the trouble shooting section
for information on possible error codes.
2. TK-TV01 Vent Terminator
This terminator can be used
where a T-K2 is going to be
vented out through a wall. This
is a CSA tested Takagi
component. Connect the
Category III stainless steel vent
pipe from the top of the unit to
the backside of this terminator to exhaust flue
gases through the wall without a thimble. Install
this vent terminator in accordance with Takagi’s
installation instructions and any applicable codes.
3. TK-TV03 Vent Damper
The TK-TV03 Vent
Damper prevents the
backflow of air through
the exhaust vent. This is
a CSA tested Takagi
component. This helps
prevent harmful exhaust
gases from entering the
home, as well as helping to prevent the unit from
freezing in areas where cold air can be blown or
drawn into the exhaust system. Install this vent
damper in accordance with Takagi’s installation
instructions, and any applicable codes.
4. TK-TV04 Vent Cap
The TK-TV04 Vent Cap is
for outdoor installation with
the T-K2 water heater. The
cap is installed on the top
of the unit, instead of
connecting an exhaust
vent pipe. The cap will
prevent any debris that might be in the
environment from entering the unit and causing
damage or a fire hazard, as well as preventing
rain or other weather from entering the unit.
5. TK-BK01 Wall Mounting Brackets
The TK-BK01 Wall
Mounting Brackets
allow the T-K2 to
be installed
hanging from a
wall. It is not
necessary to
earthquake strap these heaters if these brackets
are used. If the unit is not going to be mounted
on a wall, the “L” brackets that are included with
every unit will be sufficient as earthquake
protection. Install unit and brackets according to
manufacturer’s installation instructions and any
applicable codes.

Takagi T-K1S Specifications

General

Brand	Takagi
Model	T-K1S
Category	Water Heater
Language	English