5-6
MAINTENANCE
SERVICE DATA
SAE 10W-40
SAE 15W-40
ISO VG32
ISO VG46
ISO VG68
Mixture of 50% coolant
Mixture of 30% coolant
ISO VG46
Lubricant
Location Type
Type by air temperature
When to replace
-4 14 32 50 68 86 104°F
-20 -10 0 10 20 30 40°C
Engine oil pan
Diesel engine oil
API: CJ-4 class
ACEA: E6 class
Every 250 hrs
after the initial
50 hrs.
Hydraulic oil
tank
Takeuchi genuine
hydraulic oil 46
Every 4000
hrs.***
Anti-wear hydraulic oil
Every 2000
hrs.***
Engine cooling
system
Cooling water (water +
coolant)**
SAE: J814C or J1034
Every 1000 hrs.
Transmission
API: GL-4
SAE 80W90
with LS additivated oil or UTTO
(API GL-4)
Every 1000 hrs.*Differential
Hub
King pin and Axle Molybdenum grease
—
Every 250 hrs.
Propeller shaft
Lithium based grease
EP-2
NLGI No.2
Every 250 hrs.
Slew bearing Every 50 hrs.
Working
equipment
Daily or every
10 hrs.
Levers When required
* : If the ratio of traveling time to total operating time is high, replace the gear oil earlier than
the specified time.
** : For water, use tap water (soft). Do not use well or river water. When the ambient
temperature drops below 0°C (32°F), add coolant (antifreeze). Follow the coolant
manufacturer’s instructions to determine the mixture ratio.
*** : The hydraulic oil replacement interval depends on the type of hydraulic oil being used. New
machine are delivered with Takeuchi genuine hydraulic oil 46, and the hydraulic oil
replacement intervals indicated in this manual assume that Takeuchi genuine hydraulic oil
46 is being used. When using conventional antiwear hydraulic oil, the hydraulic oil should
be replaced every 2000 hours.
API standard: American Petroleum Institute
ACEA standard: Association des Constructeurs Européens d’Automobiles
To Next Page
Loading...
Need help?
General
