EasyManuals Logo

Tanaka TCS 33EDTP User Manual

Tanaka TCS 33EDTP
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
English
Make sure the automatic oiler is working. Keep the
oil tank lled with clean oil. Never let chain run dry
on the bar.
WARNING
Never modify the unit/machine in any way. Do not
use your unit/machine for any job except that for
which it is intended.
Never use chain saw without any safety equipment
or that has faulty safety equipment. It could result in
serious personal injury.
Using guide bar/chain other than recommended by
the manufacturer which are not approved, could
result in a high risk of personal accidents or injury.
Fuel safety
Mix and pour fuel outdoors and where there are no
sparks or ames.
Use a container approved for fuel.
Do not smoke or allow smoking near fuel or the unit/
machine or while using the unit/machine.
Wipe up all fuel spills before starting engine.
Move at least 10 feet (3 m) away from fueling site
before starting engine.
Stop engine and let it cool for a few minutes before
removing fuel tank cap.
Empty the fuel tank before storing the unit/machine.
It is recommended that the fuel be emptied after
each use. If fuel is left in the tank, store so fuel will
not leak.
Store unit/machine and fuel in area where fuel vapors
cannot reach sparks or open flames from water
heaters, electric motors or switches, furnaces, etc.
WARNING
Fuel is easy to ignite or get explosion or inhale
fumes, so that pay special attention when handling
or lling fuel.
Cutting safety
Do not cut any material other than wood or wooden
objects.
For respiratory protection, wear an aerosol protection
mask when cutting the wood after insecticide has
been applied.
Keep others including children, animals, bystanders
and helpers outside the hazard zone. Stop the
engine immediately if you are approached.
Hold the unit/machine rmly with the right hand on
the rear handle and the left hand on the front handle.
Keep rm footing and balance. Do not over-reach.
Keep all parts of your body away from the mu er
and cutting attachment when the engine is running.
Keep Bar/Chain below waist level.
Before felling a tree, the operator must be
accustomed to the sawing techniques of the chain
saw.
Be sure to pre-plan a safe exit from a failing tree.
While cutting, hold saw rmly with both hands with
thumb rmly locked around front handle, and stand
with feet well balanced and your body balanced.
Stand to the side of the saw when cutting - never
directly behind it.
Always keep the spiked bumper face to a tree,
because the chain may suddenly be drawn into a
tree, if so equipped.
When completing a cut, be ready to hold up the units
as it breaks into clear, so it will not follow through and
cut your legs, feet or body, or contact an obstruction.
Be alert against kickback (when saw kicks up and
back at operator). Never cut with the nose of the bar.
When relocating to a new work area, be sure to
shut off the machine and ensure that all cutting
attachments are stopped.
Never place the machine on the ground when
running.
Always ensure that the engine is shut o and any
cutting attachments have completely stopped before
clearing debris or removing grass from the cutting
attachment.
Always carry a rst-aid kit when operating any power
equipment.
Never start or run the engine inside a closed room
or building and/or near the inflammable liquid.
Breathing exhaust fumes can kill.
Maintenance safety
Maintain the unit/machine according to
recommended procedures.
Disconnect the spark plug before performing
maintenance except for carburetor adjustments.
Keep others away when making carburetor
adjustments.
Use only genuine Tanaka replacement parts as
recommended by the manufacturer.
CAUTION
Do not disassemble the recoil starter. You may get
a possibility of personal injury with recoil spring.
WARNING
Improper maintenance could result in serious engine
damage or in serious personal injury.
Transport and storage
Carry the unit/machine by hand with the engine
stopped and the mu er away from your body.
Allow the engine to cool, empty the fuel tank,
and secure the unit/machine before storing or
transporting in a vehicle.
000BookTCS33EDTPUS.indb6000BookTCS33EDTPUS.indb6 2012/09/1418:40:262012/09/1418:40:26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tanaka TCS 33EDTP and is the answer not in the manual?

Tanaka TCS 33EDTP Specifications

General IconGeneral
BrandTanaka
ModelTCS 33EDTP
CategoryChainsaw
LanguageEnglish

Related product manuals