TanGO TX1 - Page 26

20
Table 3.2 Display screens, indicators, and abbreviations
Process and time-based indicators
The zero icon is used in combination with other indicators to communicate sensor zero information.
The bump test icon is used in combination with other indicators to communicate bump test
information.
The calibration icon is used in combination with other indicators to communicate calibration
information.
The peak reading is the highest detected gas reading. Always clear the peak reading after calibration.
A process is in progress. In configuration mode, indicates a time-based setting (e.g. bump test
response time).
Used in combination with other indicators to communicate maintenance required warnings. In
configuration mode, indicates a date-based setting (e.g., bump test interval).
Gas name and unit-of-measure abbreviations
Carbon Monoxide (CO)
Carbon Monoxide with low Hydrogen cross-sensitivity
Hydrogen Sulfide (H
2
S or H2S)
Nitrogen Dioxide (NO
2
or NO2)
Sulfur Dioxide (SO
2
or SO2)
PPM
Parts per million is the unit of measure for CO, CO/H
2
Low, SO
2
, NO
2
, and H
2
S.
Configuration abbreviations
Country of Origin
Display Style
Dock Due option
Enable Gas-alert
Language
Maintenance indicator interval
Dock “SYnC” Interval
TWA – STEL
Vibrating Alarm Enabled
Other abbreviations
Short-term exposure limit. Display variations: “STEL” (English) and “VLE” (French).
Time-weighted average. Display variations: “TWA” (English) and “VME” (French).