6
Service and Warranty
Service Instructions
Supplies
Three-dimensional Diagrams
Service Tasks
Warranty Policy
Limitation of Liability
Service Instructions
Perform all service tasks on a nonconductive surface in a well-lit area that is known to be nonhazardous.
Wear grounding straps to prevent electrostatic discharge (ESD) which can cause damage to the unit's
electronics.
When working with the adhesive-backed filters and gaskets:
Be careful not to pierce or tear these items.
When using tweezers, apply gentle pressure.
Once the adhesive touches a surface, any attempt to remove or reposition the item may cause it
damage.
When working with sensors and the case top's water barriers:
Do not touch the white membranes as this can contaminate these items.
Use care not to damage the membranes.
Use care not to separate the sensor from its membrane.
SUPPLIES
T10 Torx screwdriver (for case bottom and clip screws)
Needle-nose tweezers (for barrier and filter service tasks)
To Next Page
Loading...