TapFlo TF50 - 4 Standard and Options; Standard; SMC Booster; Booster Without Manometers and Regulator

4. OPTIONS
IOM manual Tapflo TF series 28
4. STANDARD AND OPTIONS
4.1. Standard
As a standard Tapflo TF pump is equipped with a Festo pressure booster equipped in two
manometers and a pressure regulator. By using the knob we can regulate the output
pressure. Maximum pressure increase is 2:1. Differential pressure must be at least 2 bar.
Art. No
Pumps
6-050-99
TF50, TF70
6-100-99
TF100, TF120
6-200-99
6-400-99
TF200, TF220
TF400, TF420
4.2. SMC booster
If the client should require we offer also SMC boosters as
alternative. SMC offers also ATEX marked boosters which
can be used in zone 2:
ATEX II 3 GD c T6
If you wish to order TF pump with SMC booster please use
“19S” at the end of the pump code, e.g. TF120 STT-19S.
IMPORTANT! The SMC boosters for pump sizes T100, T200
and T400 are rated only up to 10 bar.
Additional / different parts:
Art. No
Pumps
Art. No
Pumps
6-050-99 SMC
TF50, TF70
6-050-99 SMC X
TF50, TF70
6-100-99 SMC
TF100, TF120
6-100-99 SMC X
TF100, TF120
6-200-99 SMC
6-400-99 SMC
TF200, TF220
TF400, TF420
6-200-99 SMC X
6-400-99 SMC X
TF200, TF220
TF400, TF420
4.3. Booster without manometers and regulator
If a client’s air supply line is already equipped with air
treatment system (filter-regulator, manometers etc.) it is
possible to order the pump with “plain” booster without
additional equipment. In such case, the output pressure is
always doubled in comparison to input pressure.
For this option, please use “19D” in pump code, e.g. TF100
PTT-19D.
Additional / different parts:
Art. no
Pumps
6-050-99-D
TF50, TF70
6-100-99-D
TF100, TF120
6-200-99-D
6-400-99-D
TF200, TF220
TF400, TF420