TapFlo TF50 - Aluminium; Cast Iron Pumps; Aluminium; Cast Iron Pumps - Spare Parts List; Stocking Recommendation

5. SPARE PARTS
IOM manual Tapflo TF series 32
5.5. Aluminium / cast iron pumps
5.6. Aluminium / cast iron pumps – Spare parts list
Pos.
Q-ty
Description
Material
99
1
Booster
-
990
1
Booster mounting plate
AISI 304
996
4
Booster mounting screw
A4-70
997
4
Booster mounting washer
A4-80
37
4
Additional nuts
A4-70
38
4
Additional washers
A4-70
147
4
Special pin screw
AISI 316L
5.7. Stocking recommendation
Even at normal operation some elements in the pump will be worn. In order to avoid
expensive breakdowns we recommend having a few spare parts in stock.
Depending on the severity of the operation and the importance of assuring continuous
work we offer three different spare part for plastic pumps: KIT LIQ and KIT VAL includes
parts on pump wetted side, KIT AIR includes parts on the pump air side and that are
subject to wear and two spare part kits for metal pumps: KIT LIQ and KIT AIR. Please refer
to specific series IOM manual for further details on the contents of each KIT and contact
Tapflo for KIT pricing.
It is also available to purchase spare part KITs for our FESTO pressure boosters:
SET
Description
Contents
KIT 6-050-99
Set of wearing parts
Piston module, retaining rings, seals and O-rings,
sliding piece, compression spring, perforated disk
KIT 6-100-99
Set of wearing parts
O-rings and seals, countersunk screw, lip ring,
retaining rings, distance sleeves, cone, compression
spring, , sealing piston, guiding band
KIT 6-200-99
Set of wearing parts
O-rings and seals, lip ring, retaining rings, cone,
compression spring, , sealing piston, guiding band,
stop, cartridge