Target MC18 - Diagram 6 - Blade Guard Parts List; Blade Guard Weldments and Hinges; Water Tube and Manifold Components

31
Diagram 6 – Blade Guard (Rev July 11, 2002)
BILL OF MATERIAL
INDEX P/N DESCRIPTION QTY
1 ------ Rear Guard Weldment - 18 Inch 1
2 139075 Hinge (Note A) 1
2A 195127 Hinge (Note A) 1
3 139596 Front Guard Weldment, 18 Inch (Note A) 1
3A 195120 Front Guard Weldment, 18 Inch (Note A) 1
4 020762 Washer, Flat .250 SAE (Note A) 6
4A 173059 Washer, Flat M8 (Note A) 6
5 139761 Capscrew, Hex Hd M6 x 1.0 x 20mm (Note A) 6
5A 167478 Capscrew, Hex Hd M8 x 1.25 x 25mm (Note A) 6
6 139745 Locknut, Fiber M6 x 1.0 (Note A) 6
6A 139738 Locknut, Fiber M8 x 1.25 (Note A) 6
7 139098 Splash Flap 1
8 167761 Capscrew, Hex Hd M5 x 0.8 x 20mm 4
9 173047 Washer, Flat M5 2
10 172316 Locknut, Fiber M5 x 0.8 2
11 020782 Lockwasher, Split #10 2
12 172011 Nut, Hex Hd M5 x 0.80 4
13 040330 Spring, .375 OD x .054 Dia 1
14 049212 Clamp, Water Tube 2
15 167818 Capscrew, Slot Flat Hd M6 x 1.0 x 16mm 4
16 139745 Locknut, Fiber M6 x 1.0 8
17 167046 Water Tube, 18 Inch 2
18 020864 Plug, Soc Hd 1/8 NPT Brass 2
19 139051 Gasket, Water Manifold 1
20 139045 Water Manifold, Machined 1
21 040275 Adapter, 3/8 NPT x Male Garden Hose 1
22 167551 Capscrew, Hex Hd M6 x 1.0 x 40mm 4
NOTE A:
For P/N 195127 Hinge (1/4” Thick) use P/N 195120 Front Guard Weldment – 18”
and use hardware (Item 4A, 5A & 6A).
For P/N 139075 Hinge (1/8” Thick) use P/N 139596 Front Guard Weldment – 18”
and use hardware (Item 4, 5 & 6).