EasyManuals Logo

Taski swingo 4000 User Manual

Taski swingo 4000
Go to English
437 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
94
Empty and clean the recovery tank and fresh water tank
Empty recovery tank
Empty fresh water tank
Recovery pump (optional)
Emptying at high altitudes:
Removing and cleaning the brush
Cleaning the machine
Storing / parking the machine (not in operation)
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
Remove the drain water hose from the holder.
Put the drain hose into the drainage.
Press the crushing point (1) of the drain hose.
Pull the lid off the drain hose and
drain the recovery tank.
Lift the fresh water tank (Flextank), put it into the recovery
tank at the lowest point and discharge it.
Remove the empty fresh water tank (Flextank) from the re-
covery tank and thoroughly rinse it with clean water.
Thoroughly rinse the recovery tank with clean water.
Remove the solids filter (yellow) and
empty it.
Rinse the filter thoroughly under run-
ning water.
Remove the suction filter (yellow)
and wipe off dirt using a cloth or a soft
brush.
Take out the intake filter and remove
the dirt with a cloth or a soft brush.
Attention:
Clogged suction filters may impair the suc-
tion performance.
Clogged intake filters may reduce the
amount of cleaning solution.
Reassemble the dirt sieve (yellow) and the suction filter.
Put the drain hose into the holder.
1
The machine must be switched on.
Direct the drain hose to a drain or into a bucket.
Press the button at the drain water pump.
Notice:
It is now emptied to the riser pipe in the re-
covery tank.
Notice:
Clean the brush whenever cleaning work
is completed.
The machine must be switched off.
Press the brush release with your
foot.
Remove the brushes and clean them under running water.
Attention:
Never clean the machine with a high-pres-
sure cleaner or water jet.
Water ingress in the machine may cause
considerable damage to the mechanical or
electrical parts.
Wipe the machine with a moist cloth.
Notice:
The machine must be switched off and the
key must be removed.
Notice:
Store the machine with a lifted squeegee,
lifted brush and open tank lid. Thus, the
tank can dry,
and the generation of mold and unpleas-
ant odors is prevented.
Attention:
Never store the machine with discharged
batteries. Otherwise, the batteries will be
damaged beyond repair.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taski swingo 4000 and is the answer not in the manual?

Taski swingo 4000 Specifications

General IconGeneral
Power SourceBattery
Nominal Voltage36 V
Brush Speed180 rpm
Battery Voltage36 V
Cleaning Width850 mm

Related product manuals