6. If transmission is interrupted, the ready light will stop
blinking and the remote will vibrate 3 times every 30
seconds. To synchronize the units again, place the base
and remote near each other and press and hold the
“ ” button located on the back of the base unit.
7. Auto off feature to conserve battery power: The base
unit will automatically turn off after 30 minutes if there is
no change in temperature or no buttons are pressed.
The remote unit will vibrate then automatically turn off
if the transmission signal is lost for 5 minutes. The remote
unit will also turn off automatically if the base is turned
off.
NOTE: Please recycle or dispose of batteries per local
regulations.
WARNING: Batteries may pose a choking hazard. As with
all small items, do not let children handle batteries. If
swallowed, seek medical attention immediately.
PRECAUTION: Do not dispose of batteries in fire. Batteries
may explode or leak. Remove the battery if the scale
will not be used for a long period of time.
Positioning the thermometer units
1. The base unit may be placed on a flat surface
using the clip stand on the back of the unit. It
may also be attached to a metal surface using
the magnets on the back.
2. The remote sensor’s clip stand may be used to stand
the remote on a flat surface or clip on a belt loop. The
magnets may be used to attach it to a metal surface.
Use the lanyard to wear it around the neck (take care
not to allow the remote to touch hot items or working
appliances). Simply thread the lanyard through the
opening on the remote and loop the lanyard through
itself.
3. During use, keep the base unit and remote sensor
within effective transmission range, which is 200 feet in
usual circumstances.
4
To Next Page
Loading...
Need help?
General
