16
Model 161Operating Procedures
Step 3
Press the AUTO key. When the unit cycles off, the
product will be ready to serve.
Figure 24
Note: Non--Softecht machines: Place the power
switch in the AUTO position. When the unit cycles off,
the product will be ready to serve.
Figure 25
Step 4
Momentarily raise the draw switch to activate the
refrigeration cycle.
Step 5
Place the mix hopper cover in position.
Repeat Steps 1 through 5 for the second freezing
cylinder.
Step 6
Install the front drip tray and splash shield under the
freezer door .
Figure 26
Step 7
Slide the rear drip pan into the hole in the side panel.
Closing Procedure
To disassemble the Model 161, the following items will
be needed:
S T wo cleaning pails
S Sanitized stainless steel rerun can with lid
S Necessary brushes (provided with machine)
S Cleaner
S Single service towels
To Next Page
Loading...
