Taylor 161 - Page 26

22
Troubleshooting
Model 161
PROBLEM PROBABLE CAUSE REMEDY
12.The unit will not run when in
t
h
e
A
U
T
O
m
o
d
e
The unit is unplugged. Plug into wall receptacle.
the
A
UTO mode.
The beater motor is out on reset. Allow the beater motor to cool.
Place the power switch to the
OFF position. Press the reset
button firmly. Place the power
switch to the ON position, and
press the WASH key. Open the
side access panel and observe
that the drive shaft is turning
clockwise as viewed from the front
of the unit. Press the AUTO key to
return to the AUTO mode.
Note: Do not use metal objects to
press the reset button.
The circuit breaker is off, or the
fuse is blown.
Turn the breaker on, or replace
the fuse.
Low on mix. The MIX OUT light is
on.
Add mix to the mix hopper and
press the AUTO key.
The water is turned off, on water
cooled units.
Turn the water on.
13.Product is not feeding into the
freezing cylinder.
The mix inlet hole is frozen up. The hopper temperature needs
adjustment.
Incorrect usage of the mix feed
tube.
Follow the correct feed tube
procedures and use of the air
orifice.
14.Product is “popping” when
drawn.
Thedrawrateissettoofast. The draw rate should be set at 5 -
7-1/2 oz. of product per 10
seconds.
15.The MIX LOW and MIX OUT
probes are not functioning.
There is milkstone build-up in the
hopper.
Clean the hoppers thoroughly.