How to remove a stuck drive shaft from the drive coupling in my Taylor 336?
If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
What causes scored freezing cylinder walls in my Taylor 336?
Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
Why is product collecting on top of the freezer door of my Taylor 336 Ice Cream Maker?
If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
What to do if the pump won't operate in PUMP mode on my Taylor 336?
If the pump won't operate in PUMP mode, try pushing the reset button. If that doesn't work, the membrane switch may be defective and need replacement.
Why are the MIX LOW and MIX OUT probes not working on my Taylor 336 Ice Cream Maker?
If the MIX LOW and MIX OUT probes aren't functioning, there might be milkstone build-up in the hopper. Clean the hoppers thoroughly.
What to do if my Taylor Ice Cream Maker is not dispensing product?
If your Taylor Ice Cream Maker isn't dispensing product, several factors could be at play. First, ensure the mix hopper isn't low; if the MIX OUT light is on, add mix. Next, verify the power switch is in the ON position and press the AUTO keypad. If the beater motor is out on reset, allow it to cool, turn the power switch OFF, press the reset button, turn the power switch ON, and press the WASH keypad, checking that the drive shaft turns CLOCKWISE. Then press the AUTO keypad. Also, check the air/mix pump assembly, ensuring it's correctly assembled and properly lubricated. Confirm the spring and poppet are correctly installed on the mix inlet fitting, replacing if necessary. If the mix pump ball crank is broken, replace it. Ensure the pump motor is activated by pushing the reset button and ...
Review installation area for hazards and follow safety protocols, including PPE.
Guidelines for water supply and electrical hookup.
Details on refrigerants, safety, and environmental impact.
Paramount safety instructions to prevent injury or damage.
Key safety rules for electrical installations and operation.
Guidelines for safe operation, including personnel and moving parts.
Preparing solution and cleaning the mix hopper and components.
Completing sanitizing by agitating and draining.
Initial priming steps to flush sanitizing solution with mix.
Detailed steps for cleaning the machine.
Checklist for proper cleaning and sanitizing.
Steps to address high bacterial counts.
Troubleshooting steps for no product output.
Diagnosing and resolving product stiffness.
Addressing issues with mix being too warm or cold.
Resolving issues with unit operation and product feeding.
Troubleshooting drive shaft binding and mix leaks.
General| Brand | Taylor |
|---|---|
| Model | 336 |
| Category | Ice Cream Maker |
| Language | English |
To Next Page
