Taylor 432 - Troubleshooting Guide; No Product Dispensed; Machine Not Operating in Auto;Wash; No Compressor Operation in Auto

27
Model 432 Tim Hortons Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. No product being
dispensed.
a. Control switch is in the
“OFF” position.
a. Place control switch in the
“AUTO” position.
21
b. Improper mixing of
product.
b. Carefully follow directions
for mixing product.
- - -
c. Inadequate mix in hopper. c. Fill hopper with mix.
21
d. Product has frozen-up in
the freezing cylinder.
d. Adjust viscosity
adjustment accordingly.
13
e. Unit out on reset. e. Place control switch in the
“OFF” position. Press the
reset button. Return the
control switch to “AUTO”.
13
f. Unit is unplugged at wall
receptacle.
f. Plug in power cord.
- - -
g. Tripped circuit breaker or
blown fuse.
g. Reset circuit breaker or
replace fuse.
- - -
h. Beater assembly is
rotating counterclockwise.
h. Contact an authorized
service technician.
- - -
2. Unit will not operate in the
“AUTO” or “WASH” mode.
a. Unit unplugged at wall
receptacle.
a. Plug in power cord.
- - -
b. Tripped circuit breaker or
blown fuse.
b. Reset circuit breaker or
replace fuse.
- - -
c. Unit out on reset. c. Place the control switch in
the “OFF” position. Press
the reset button. Return
control switch to “AUTO”.
13
3. No compressor operation
in the “AUTO” mode.
a. Beater motor is out on
overload.
a. Place control switch in
“OFF” position. Press the
reset button. Return
control switch to “AUTO”.
13
b. Condenser is dirty
(air-cooled units).
b. Clean condenser monthly.
25