OPERATING PROCEDURES
6-3
Model 432
Operating Procedures
6
8. Install the O-rings on the draw valve and lubricate.
Figure 6-8
9. Insert the draw valve into the door, leaving
approximately half of the valve sticking out the top of
the door.
Figure 6-9
10. Rotate the draw valve so the flats on the top of the
draw valve are perpendicular to the door face.
Figure 6-10
11. Insert the ice buster through the door spout and into
the slot located just above the lower O-ring.
Figure 6-11
12. With the ice buster in place, rotate the draw valve to
allow installation of the draw handle. This will lock the
ice buster in place. Install the draw handle pin, and
close the draw valve by moving the handle to the left.
Figure 6-12
101611
101650
101644
101612
To Next Page
Loading...
