11
Model C602
Systems, Controls and Operations
Symbol Definitions
To better communicate in the International arena,
the words on many of our operator keys have been
replaced by symbols to indicate their functions. Your
Taylor equipment is designed with these
International symbols.
The following chart identifies the symbol definitions.
=AUTO
= HEAT CYCLE
= WASH
=MIXPUMP
= STANDBY (SHAKE)
= STANDBY (SOFT SERVE)
= FLAVOR SELECTION
=MIXLOW
= MIX OUT
= TOPPING HEATER-LEFT
= TOPPING HEATER-RIGHT
=CALIBRATE
= MENU DISPLAY
Power Switch
When placed in the ON position, the power switch
allows control panel operation.
Vacuum Fluorescent Display
The vacuum fluorescent display (VFD) is located on
the front control panel. During normal operation the
display is blank. The display is used to show menu
options and notifies the operator if a fault is
detected. On International models, the display will
indicate the temperature of the mix in each hopper.
Indicator Lights
MIX LOW - When the MIX LOW symbol is
illuminated, the mix hopper has a low supply of mix
and should be refilled as soon as possible.
MIX OUT - When the MIX OUT
symbol is
illuminated, the mix hopper has been almost
completely exhausted and has an insufficient supply
of mix to operate the freezer. At this time, the AUTO
mode is locked out and the freezer will be placed in
the STANDBY mode. To initiate the refrigeration
system, add mix to the mix hopper and touch the
AUTO symbol
. The freezer will automatically
begin operation.
To Next Page
Loading...
