Taylor C602 - Page 33

30
Systems, Controls and Operations
Model C602
040608
CAL SYRUP TIME
This option allows the service technician to adjust
the Calibrate Syrup Time which determines the flow
rate of the syrup.
Example: 1 oz.(28 g) syrup dispensed in 5 seconds.
The recommended Cal Syrup Time for standard
shakes is 5.0 seconds and is 7.0 seconds for Triple
Thick Shakes.
The following screen is displayed by selecting this
option: (See Figure 70.)
CAL SYRUP TIME
TIME : 5.0 SEC
Figure 70
Select the AUTO symbol
to increase the time
setting or the OPTIONAL FLAVOR symbol
to
decrease the setting. Select the CALIBRATION
symbol
to save the setting and return to the
Service Menu.
DRAW SAFETY TIME
This option allows the service technician to adjust
the Draw Safety Time used for closing the shake
draw valve in the AUTO Mode if the fill level is not
detected by the portion control sensor. The Draw
Safety Time should be set approximately 5 seconds
longer than the amount of time it takes to fill the
largest serving size.
The following screen is displayed by selecting this
option. (See Figure 71.)
DRAW SAFETY TIME
TIME : 11 SEC
Figure 71
Press the AUTO symbol
to increase the Draw
Safety Time setting or the OPTIONAL FLAVOR
symbol
to decrease the setting. Select the
CALIBRATION symbol
to save the setting and
return to the Service Menu.
EDIT UNIT ID
This option allows the service technician to enter the
factory Bill of Material (B.O.M.) code used to
assemble the machine, the freezer Serial Number
and the Store Identification Number. This
information must be programmed in the service
menu in order to view the information in the
SYSTEM INFORMATION screens. (See Figures 72,
73 & 74.)
ENTER FREEZER BOM
C600000000
_
Figure 72
Select the AUTO symbol
to increase the value or
OPTIONAL FLAVOR symbol
to decrease the
value. Select the CALIBRATION symbol
to move
the cursor to the right and advance to the serial
number screen.
ENTER FREEZER SN
K0000000
_
Figure 73
Enter the serial number from the unit’s data label in
the same manner as the BOM, then select the
CALIBRATION symbol
to save the setting and
advance to the store identification screen.
ENTER STORE ID
00000
_
Figure 74
Enter the store number, then select the
CALIBRATION symbol
to save the setting and
return to the Service Menu.